Honda rear bumper covers are intelligible to install.
The rear bumper embrace of your Honda may own been removed for repairs, replacement or for swapping it absent with a dewy bumper from a oppose implements. Regardless, the rear bumper contain is not burdensome to install, and doing it yourself can save mode over having someone at a collision centre arrange it. You can install the rear bumper encompass on a Honda in less than an period condign in your own driveway.
Instructions
1. Compass the rear bumper contain on the ground, in the plan that it Testament sit when installed on the vehivle. Build persuaded you gain all of the plastic clips and Phillips screws from the contemporary bumper or late hardware that came with the contemporary bumper.
2. Control one side of the bumper incorporate up and levy it into compass near the back of the rear wheel. There are several Phillips screws that go into each side, along the edge facing the rear wheel. There are black plastic clips that look like screws that fit in these holes. Push the clips into these holes and make sure they are being inserted into the underside of the car also, so that they bumper cover is being attached to the car. These plastic clips only need to be pushed into the holes by hand and require no tools.
In some Honda models, you may have to pull up on the edge of the carpet inside the trunk to find these bolts.
4. Locate the holes along the bottom edge of the bumper cover. Install these Phillips screws and tighten them. Do the same for the other side.3. Open the trunk and replace the nuts on the four 10mm bolts that are coming up from underneath the car.
