To remove an Sole coil, disconnect its electrical connector, remove its mounting bolt with a wrench and lift the coil up off the Glimmer plug.On other models, the ignition coil pack is on the left-hand side of the cylinder imagination. Pull Everyone of the Glimmer plug wires off of the coil pack, creation confident you perceive which wire goes to which terminal, and then unbolt and remove the coil pack.
Starter Motor
Ignition Coils
Conceive undeniable the engine is shut off and disconnect the cynical battery cable before installation.
Most Seat models prepared thanks to 2005, or ones with a 2.3-liter engine, posses the distinct coils bolted over the Glimmer plugs.The spark plugs daily grind with the ignition coils.The leading components in the Ford Heart' ignition process are the starter Engine, the ignition coils and the Glimmer plugs with their wires. The measure of removing Everyone Element varies slightly depending on the type of engine your Ford Target uses and maybe its year.
Raise the front end of the car and support it on axle stands to access the starter motor.
If the car has a 2.0-liter SPI engine, it helps to remove the air cleaner outlet tube from the throttle body; use a Phillips head screwdriver to loosen the tube's clamp.
If the car uses a Zetec engine, remove the MAF sensor with the PVC pipe so you can reach and remove the upper bolts, then remove the lower bolts from underneath the car. For a 2005 or later car, unbolt the power steering pump with your wrench and set it aside without disconnecting its lines.
Once you remove the starter motor's mounting bolts, pull it off the dowels mounting it to the transaxle housing; you might need to turn it to an angle due to its close quarters within the engine.
Spark Plugs
If the Focus has ignition coils installed over the spark plugs, remove the individual coils as described in Section 1. Otherwise, the plugs are connected to the coil pack by wires. Grasp the wire by its boot to remove it from the plug; if you need to remove the wire completely, pull it off the coil pack as well.
You need a wrench with a spark plug socket to remove the plug. Insert the socket into the spark plug hole and turn it counterclockwise to remove it from the engine.
