6. Insert the hose adapter into the small inlet hole on the intake tube. Your homemade cold air intake for your Jeep TJ is now built.
Instructions
1. Comprehend the chill air intake leading tube in the gap terminated the heat shield.
2. Deposit the conical filter on the confine of the intake tube that you placed buttoned up the heat shield. Secure it with a hose clamp using a flat-head screwdriver.
3. Capitalization a ratchet and socket wrench To button up two L brackets to the heat shield in the pre-drilled holes using the nuts and bolts that come with the heat shield.
4. Assign a three-inch silicone connexion hose on the other borderline of the crisp air intake tube. Custom a flat-head screwdriver to secure it with a hose clamp.
5. Deposit foam insulation enclosing the column of the heat shield. This will make sure that no moisture goes into the intake filter.
The Jeep Wranglers that were released from 1997 to 2006 in North America were down pat as TJs. The TJ came with either a four- or six-cylinder engine that produced between 110 and 190 horsepower. While this is augmented than Sufficiently to impel the lightweight TJ, faculty enthusiasts can easily add a unusual additional horsepower to their TJ by building their own algid air intake. A chill air intake replaces the inventory air intake in the TJ and sucks in arctic air from absent of the engine compartment.7. Open the TJ hood and locate the large, black, stock air intake tube. Remove the hose clamps on each end of the tube using a flat-head screwdriver. Remove the intake tube. Push up the clips on the stock air filter box and remove the top of the filter box.
8. Remove the bolts holding the filter box to the fender wall using a ratchet and socket wrench. Disconnect the electrical wire harness from the mass air flow (MAF) sensor on the side of the filter box. Pull the MAF sensor out of the filter box. This is the only sensor on the filter box.
9. Remove the filter box from the engine compartment. Bolt the heat shield brackets of your homemade cold air intake to the mounting holes of the stock filter box. Connect the end of the cold air intake tube to the throttle body. Use a flat-head screwdriver to tighten the hose clamp securing it.
10. Push the MAF sensor into the only opening in the intake tube and reconnect its electrical wire harness. Your installation is complete.
